Brand NEW Website. SAME Great Products!

Maine Coast Marine Products

Measurement Guide

IMPORTANT NOTE: It is critical that you obtain accurate measurements of your fenders in order to ensure you order the right size cover.

DO’s and DON’Ts:

  • Don’t try to measure the diameter; always measure the circumference.
  • Don’t use a standard tape measure that might kink as you take the circumference causing inaccurate measurements; always use a soft tape measure or a piece of rope.
  • When measuring length, don’t drape the tape measure over the ends of the fender; always measure from the very end to the very end using a straight tape or yardstick (please see the figure below or refer to our video guide).
  • When measuring a DOUBLE-EYE FENDER, please INCLUDE the eyes in your straight length measurement as this is how manufacturers report length (please see the figure below).  However, if you have a brand other than Taylormade or Polyform, it would also be useful to include the length of the body of the fender EXCLUDING the eyes.

Check out these fender measurement video demonstrations!

Center-hole Style Fenders

Double-eye Style Fenders

Round Fenders

Maine Coast Marine Products
4 Scammon Street, Suite 19-310
Saco, Maine 04072

Tel: 1-207-710-2021